Hi Everyone! Lyne here with a bottle cap embellishment tutorial for ScrapMuch!? I’ll be showing you how to create the cap I used on my Cool Kid layout. Here’s a close up…
For this you will need some bottle caps, a manual die cut machine, liquid adhesive, a 1 inch circle punch and some epiphany crafts epoxy stickers in size 14.
To get started set your die cut machine up with platform one.
Place your clear cutting pad down, then the bottle cap facing down, and the top clear plate.
Once you run it through the machine you’ll end up with something like this:
I do find that the cap you use does make a difference. I found some at hobby lobby that were on clearance with a soda design on the back. They don’t work so well as they tend to flatten too much, but the Spare Parts caps work perfectly.
Now use your circle punch to punch out the design you are looking to make into an embellishment.
Place some strong liquid glue on the cap and then place your circle punch on top. Allow to dry for a few seconds.
Lastly, apply your epoxy cap and you’re ready to use
You can also do this, but use the back of the cap instead.
I did this on my Scrappy Friends layout. This one I had a hard time getting a good photo of, but if you go check out the layout it’s on the right hand side at the top.
I hope you’ve learned something new today, and I’d love to see what you create using this technique. Until next time…Happy Scrapping!
This is so wonderful. Thank you for sharing it with us at ScrapMuch??
duh!!! I never thought of flattening them! I always find them so bulky!!! awesome instructions! I will be flattening the ones I have! thanks
Alicia